Woodworking Pattern How to make a copier model for your woodturning lathe

Woodworking Pattern

Woodworking Pattern

Woodworking Pattern

Woodworking Pattern

Drill a hole 10-bolt to 40 in a stop of each finger centered one/2 "from the stop. Mount messages using the knife on the table corner now fueling the lathe-chucking. Use a drill diameter slightly bigger than the diameter of the bolt shaft 10-40. Your fingers should evaluate 6 "wide and 3/4" wide. Sand fingers easy removing seen signs and smears. As you cut get ready themselves to stop slicing just your fingers about falling down lower and lower Street. Set your fingers to just fall through barely touch the depth of each cut. Buy a box of 10-40 bolts one one or two "and a wing nut and washer for each bolt.

aluminium Cutting fingers off the plate by using a 1/4 "Blade on inventory band observed. Get rid of 1 end of the tube by a vertical guide. The rest of the parts for the standard. Sample copiers are used to make replicate spindles turned from one Woodworking Pattern . The style of this standard Copier incorporates numerous lathe tracer "fingers" suspended the tornio side of aluminum tube. Aluminum bars must be free to move up and down Woodworking Pattern . Start cutting and cease any finger falls. Aluminum foil thickness you will also require some 1/8 "or you can buy some aluminum cookie sheets.

Cut another 1/8 "slot 1" deep and centered on 1 ' dimension at the correct angle to the bore of the bolt. Be aware of external diameter aluminum pipe and drill a hole the size at the top of each post. Bob Gillespie © 2010 Woodworker Robert M. Drill a hole again about 1 diameter identical or two "from the other end of the block centered with the blocking of laying flat on the table and drill press. Make a bunch of blocks of wood 3/4 "x 1" x 6 "extended.

now you can fit the blocks along the tube before exchanging the tube in vertical media publishes your standard Copier lathe. Wish (4) three "angle irons with screws as well. Both ends should be completely rounded (RADIUS 3/8 ") on a Board belt or disc Sander Woodworking Pattern. With the blocks lying flat lower through the finish line in the hole with a 1/8 "Blade observed table.

Woodworking Pattern

Woodworking Pattern

Woodworking Pattern

Woodworking Pattern

Woodworking Pattern

Woodworking Pattern

Date: 2012.08.23 Category: Category: None Comments (1) Trackbacks (0)

この記事へのComments:

-

Date2014.03.27 (木) 01:27:11

Comment is pending blog author's approval.

管理人のみ通知 :

Trackbacks: